| SSL_do_handshake(3) - phpMan
SSL_do_handshake(3SSL) OpenSSL SSL_do_handshake(3SSL)
NAME
SSL_do_handshake - perform a TLS/SSL handshake
SYNOPSIS
#include <openssl/ssl.h>
int SSL_do_handshake(SSL *ssl);
DESCRIPTION
SSL_do_handshake() will wait for a SSL/TLS handshake to take place. If the connection is
in client mode, the handshake will be started. The handshake routines may have to be
explicitly set in advance using either SSL_set_connect_state(3) or
SSL_set_accept_state(3).
NOTES
The behaviour of SSL_do_handshake() depends on the underlying BIO.
If the underlying BIO is blocking, SSL_do_handshake() will only return once the handshake
has been finished or an error occurred, except for SGC (Server Gated Cryptography). For
SGC, SSL_do_handshake() may return with -1, but SSL_get_error() will yield
SSL_ERROR_WANT_READ/WRITE and SSL_do_handshake() should be called again.
If the underlying BIO is non-blocking, SSL_do_handshake() will also return when the
underlying BIO could not satisfy the needs of SSL_do_handshake() to continue the
handshake. In this case a call to SSL_get_error() with the return value of
SSL_do_handshake() will yield SSL_ERROR_WANT_READ or SSL_ERROR_WANT_WRITE. The calling
process then must repeat the call after taking appropriate action to satisfy the needs of
SSL_do_handshake(). The action depends on the underlying BIO. When using a non-blocking
socket, nothing is to be done, but select() can be used to check for the required
condition. When using a buffering BIO, like a BIO pair, data must be written into or
retrieved out of the BIO before being able to continue.
RETURN VALUES
The following return values can occur:
0 The TLS/SSL handshake was not successful but was shut down controlled and by the
specifications of the TLS/SSL protocol. Call SSL_get_error() with the return value ret
to find out the reason.
1 The TLS/SSL handshake was successfully completed, a TLS/SSL connection has been
established.
<0 The TLS/SSL handshake was not successful because a fatal error occurred either at the
protocol level or a connection failure occurred. The shutdown was not clean. It can
also occur of action is need to continue the operation for non-blocking BIOs. Call
SSL_get_error() with the return value ret to find out the reason.
SEE ALSO
SSL_get_error(3), SSL_connect(3), SSL_accept(3), ssl(3), bio(3), SSL_set_connect_state(3)
1.0.1t 2016-05-03 SSL_do_handshake(3SSL)
|